Mounting eMMC to SD Adapter
Posted: Tue Feb 07, 2017 1:07 pm
Hi everyone,
I desoldered an eMMC to save my data from it.
This is the exact type of the eMMC:
http://www.datasheets360.com/part/detai ... cturerId=0
I desoldered it using a rework station. Quite sure it should still be ok.
Then connected
eMMC pin - micro SD adapter pin
DAT0 - DAT0
DAT1 - DAT 1
DAT2 - DAT2
DAT3 - DAT3
Vss - Vss
Vcc - Vdd
CLK - CLK
CMD - CMD
Did I do anything wrong with the transition from MMC to the microSD adapter?
Vssq and Vddq don't have to be connected?
Or can I drop all the other DAT lines and only use DAT0 and need to connect Vssq and Vddq, as I don't understand the reason of ..q lines.
Thought this might be the right place to post, even though its not a GTV:)
Hope that's ok.
Thanks!!
I desoldered an eMMC to save my data from it.
This is the exact type of the eMMC:
http://www.datasheets360.com/part/detai ... cturerId=0
I desoldered it using a rework station. Quite sure it should still be ok.
Then connected
eMMC pin - micro SD adapter pin
DAT0 - DAT0
DAT1 - DAT 1
DAT2 - DAT2
DAT3 - DAT3
Vss - Vss
Vcc - Vdd
CLK - CLK
CMD - CMD
Did I do anything wrong with the transition from MMC to the microSD adapter?
Vssq and Vddq don't have to be connected?
Or can I drop all the other DAT lines and only use DAT0 and need to connect Vssq and Vddq, as I don't understand the reason of ..q lines.
Thought this might be the right place to post, even though its not a GTV:)
Hope that's ok.
Thanks!!