Mounting eMMC to SD Adapter

Looking for help doing something. This is one of the best places to start.
Post Reply
vortex
Android 1.0
Posts: 1
Joined: Tue Feb 07, 2017 12:21 pm

Mounting eMMC to SD Adapter

Post by vortex » Tue Feb 07, 2017 1:07 pm

Hi everyone,

I desoldered an eMMC to save my data from it.
This is the exact type of the eMMC:
http://www.datasheets360.com/part/detai ... cturerId=0

I desoldered it using a rework station. Quite sure it should still be ok.
Then connected
eMMC pin - micro SD adapter pin
DAT0 - DAT0
DAT1 - DAT 1
DAT2 - DAT2
DAT3 - DAT3
Vss - Vss
Vcc - Vdd
CLK - CLK
CMD - CMD

Did I do anything wrong with the transition from MMC to the microSD adapter?
Vssq and Vddq don't have to be connected?
Or can I drop all the other DAT lines and only use DAT0 and need to connect Vssq and Vddq, as I don't understand the reason of ..q lines.

Thought this might be the right place to post, even though its not a GTV:)

Hope that's ok.

Thanks!!

danilojc
Android 1.0
Posts: 1
Joined: Wed May 23, 2018 12:02 pm

Re: Mounting eMMC to SD Adapter

Post by danilojc » Wed May 23, 2018 12:57 pm

what I understood about this, is that:
1 - eMMC has 8 data lines while SD has 4 data lines. So there is no way to connect all datalines. Then you need to test if SD adapter can work with 1-bit data transfer, and if positive, connect just D0.
2 - SD card works with 3V, and eMMC works with 3V at VCC and 1.8V at VCCq. So you need to provide these levels of voltages to VCC and VCCq externally;
3 - Sometimes is needed to use pull-ups resistors at CMD and D0 pins.
4 - I saw that reset pin need to be putted in high level, but usually this pin position is not shared in ISP pinout, so maybe this is not so important...

I also tried to extract data from eMMC chips but got no success on that... maybe there is some other hidden information to perform it? Anyone can help?

Post Reply
 

 

cron

Login  •  Register